|
THIS WHEEL DRESSER WILL DRESS TWO ANGLES
TANGENT TO A RADIUS IN ONE CONTINUOUS MOTION
WITH .0001(0.002mm) ACCURACY.
IT IS EQUIPPED WITH A MICROMETER FEED
OF 1-3/16" (38mm). THE DIAMOND RETURNS AUTOMATICALLY TO THE CENTER POSITION AFTER DRESSING ANGLES.
THERE IS NO NEED TO PRE-SET THE DIAMOND. THE ONLY TOOLS REQUIRED ARE, A MICROMETER AND A HEX WRENCH. NO NEED OF A GAGE BLOCK, MASTER GAGE SETTING, JO BLOCK, PARALLEL BAR, SURFACE PLATE, HEIGHT GAGE OR DIAL INDICATOR. YOU NEED NOT MOVE DOVETAILS TO FORM ANGLES. THE ANGLE IS DRESSED BY CONTINUING TO PUSH THE HANDLE IN BOTH DIRECTIONS AFTER THE RADIUS IS FORMED.
GIBS & V-WAYS ARE ONLY USED FOR POSITIONING SURFACES.
THIS WHEEL DRESSER GENERATES CLEAN, PRECISE WHEEL PROFILES ENTIRELY FREE OF CHATTER MARKS. YOU GET A PERFECT BLEND OF ANGLES AND RADII.
PRECISE SHARP CONCAVE OR CONVEX CONTOURS AT A FULL 180 DEGREES, ARE OBTAINED CONSISTENTLY WITH GUARANTEED 0.0001" ACCURACY.
CONVEX RANGE: ZERO TO 3 INCHES (0-76mm)
CONCAVE RANGE: 1/32" TO 3-1/2" (0.8mm TO 89mm)
THIS WHEEL DRESSER ATTACHMENT WILL HOLD INTERSECTING ANGLES 12 TO 15 SECONDS. THIS IS ACCOMPLISHED BY OPERATING UPRIGHT AND HANDLE. SETTING UP TWO ANGLES REQUIRES 10 SECONDS. SETTING TWO ANGLES AND RADIUS REQUIRES LESS THAN 3 MINUTES.
THIS WHEEL DRESSER ATTACHMENT IS THE MOST DURABLE DRESSER AVAILABLE. MANUFACTURED FROM HARDENED, GROUND AND LAPPED ALLOY STEEL. THERE ARE NO WEAR SURFACES, IT SWIVELS ON SEALED BEARINGS.
THIS FORM TANGENT IN ONE SETTING--TWO ANGLES--TWO RADII--ONE FLAT.
CONCAVE AND CONVEX FORMS IN ONE SETTING WITH FLAT BETWEEN RADII ARE POSSIBLE WITH SPECIAL STOPS ON OUR STANDARD SERIES RADII AND ANGLE WHEEL DRESSER ATTACHMENT.
ANGLES MAY BE DIFFERENT. RADII MUST BE THE SAME SIZE. LENGTH OF FLAT IS CONTROLLED BY STOPS SET ON CROSS FEED OF MACHINE TABLE.
|
